#How to reset cisco switch password

Wait until the reload or erase finishes and a CLI prompt or completion message appears.

Note1: you dont need to enter 0 or 7 - try that.

#How to reset cisco switch password

Would you like to enter the initial configuration dialog? noВ Дo you want to save the configuration of the AP? no switch>enable switch config t Switch (config)username gozulin privilege 15 password yourpassword Switch (config)end switch wr.

In the router CLI, enterВ the commands in boldface to erase the existing configuration on your router and reload the factory-defaultВ configuration on the router:Д®rasing the nvram filesystem will remove all configuration files! Continue?.

On your laptop, start the terminal emulator program and use it to access your routerвЂ™s command line interface (CLI).

You can check the lights on the router - when the lights are solid or blink in repeating patterns, the router is finished booting.

Power on the router and wait 5 to 10 minutes for the router to finish booting.

Connect your laptop to the consoleВ port on your router with the console cable.

With yourВ router powered off, connect the power cord to theВ router, and plug the power cord into your power source.

To reset your router to its factory-default configuration using router commands: You can check the lights on the router - when the lights are solid or blink in repeating patterns, the router is finished booting.ДЄt this point, your router is reset and will boot intoВ its factory-default configuration the next time you power it on.

Wait 5 to 10 minutes for the router to finish booting.

Release the Reset button after 10 seconds.

Press and hold the Reset button while you power on the router.

With theВ router powered off, connect the power cord to your router, and plug the power cord into your powerВ source.To reset your router to its factory-default configuration using the Reset button: If you needВ additional information or help to reset your router, try the resetВ steps in Reset Router to Factory Settings, see the Cisco support document Reset a Cisco Router to Factory Default Settings, refer to the documentation for your router model, orВ contact Cisco dCloud Support. Using a pin, press and hold the Reset button on the switch for 15 to 20 seconds. Disconnect all Ethernet cables from the switch. ResetВ Router Using Router Commands вЂ“ For routers without Reset buttons When the switch fails to work and cannot be reset by using the web-based utility, the switch can be manually reset to restore the factory default configuration.Reset Router Using Reset Button вЂ“ For routers with Reset buttons.

2022.03

How to reset cisco switch